Mark On Cylinder (2) - Panasonic LP-M Series Operation Manual

1-4-4 Mark on Cylinder (2)

„ Sample
Length of Cylinder: 24 mm
Original Point of
Local Coordinate
Original Point of
World Coordinate
28mm
„ Setting Flow
1. Set the cylinder.
Set the size, angle, and center position of the cylinder.
2. Set the marking condition.
Set the character type and character position to be marked on the cylinder.
64
Diameter: 18 mm
Marking Image
Rotation Angle Z: -90 degree
＋
Z
18mm
Marking Figure
[Setting of figure]
• Layer No.
• Work Shape
• Diameter
• Length
• Rotation Angle
• Center Position X
• Center Position Y
• Center Position Z
[Character condition]
• Marking content
• Starting Coordinate X
• Starting Coordinate Y
• Character Height
• Character Width
• Character Interval
• Rotation Angle
Center of
3D Figure
9mm
Original
Point of
Local
Coordinate
ME-LPMSZ-OP-7
: 0
: Cylinder Convex
: 18 mm
: 24 mm
: -90 degree
: 28 mm
: 18 mm
: 9 mm
: ABCD
: 2 mm
: -8 mm
: 4 mm
: 3 mm
: 4 mm
: 90 degree
Rotation
Y
Angle: 90 degree
(Character Condition)
X
‑8mm
X Position, Y Position
(Character Condition)
2mm
Marking Character