Panasonic LP-M Series Operation Manual page 182

Description
5 X/Y Position :
Shifts the object to X/Y direction for each radiation point.
Setting Range
6 Radiation Time :
Specifies the laser radiation time.
Setting Range
7 Laser Power Correction :
Correction of each radiation point for the laser power set at laser setting.
If the correction rate is set to 0%, the marking image is displayed in gray and marking is not executed.
Setting Range
8 INPUT :
Pressing INPUT button establishes the specified radiation position and time.
9 DELETE :
Pressing DELETE button deletes the selected radiation position and time.
10 ALL DEL :
Pressing ALL DEL button deletes all radiation position and time in the table.
11 List of Point Radiation Conditions :
Displays the setting condition radiation position and time. Up to 50 radiation points can be set in one condition list.
* For the setting range of the other model, refer to "Input Setting Value by Series" (P.296).
WARNING
182
-60.000 to +60.000 mm (LP-M500 / LP-Z130)*
-45.000 to +45.000 mm (LP-S500)*
0.1 to 99999.9 ms
0 to 999%
• Since the arbitrary point radiation function carries on radiating the laser onto
the one point, it will provide high energy density.
It may flame up or burn depending on the material to be used for processing or
processing condition.
ME-LPMSZ-OP-7