Panasonic LP-M Series Operation Manual page 137

Vertical projection marking method
With this method, the laser marker performs the marking on the 3D figure like vertical-projecting marking content onto the
3D figure.
Target type of 3D figure: vertical cone (marking on convex /concave face), sphere (marking on convex /concave face)
Character
Starting
Position
Marking image on convex face of sphere viewing from top
Reference
• When marking on cylinder and cone, set the starting position of marking content X and Y by measuring the length on
curved face.
• When setting status of the marking content exceeds the figure area (see figure below) and starting marking, the marking
error (E671/E672) is occurred and the laser marker cannot perform marking. Therefore, check the marking content
using "3D View Screen" ("2-14-3 3D View Screen" (P.213)‚ and perform guide indication of the marking character before
marking. When the marking content is displayed within the figure area, start the marking.
Marking image cone with its heightwise set
parallel to Z axis
Marking Character "ABCDEFGHIJKLMNOPQR"
ME-LPMSZ-OP-7
ABCDEFGH
B C
A
Marking image on convex face of sphere
D E F G
H
Sticking-like image
137