Panasonic LP-M Series Operation Manual page 156

Description
8 X/Y Scale (only for VEC file format) :
Specifies the magnification of X/Y of the VEC file data.
Setting Range
9 Size (only for DXF file format) :
Specifies size specification method of DXF file data.
• Height/Width
• Width (Keep Ratio)
• Height (Keep Ratio)
• Original
10 Height, Width (only for DXF file format) :
Sets height / width of DXF file data.
Setting Range
11 Font (only for DXF file format):
Specifies font type to be used for the text character in DXF file data.
The setting varies by pressing this field. The font can be selected for each logo file.
12 Marking Pitch (only for DXF file format):
Sets marking pitch of the solid hatching drawing in DXF file data.
Setting Range
13 Marking Direction (only for DXF file format) :
Sets marking direction of the solid hatching drawing in DXF file data. Both vertical and horizontal directions are
settable.
14 Laser Power Correction :
Scan Speed Correction :
Laser Pulse Cycle Correction (Except LP-SxxxW type) :
Correction of each logo No. for the laser power / scan speed / laser pulse cycle set at laser setting.
Setting Range of Laser Power Correction
Setting Range of Scan Speed Correction
Setting Range of Laser Pulse Cycle Correction
Reference
• If the value of "Laser power correction" × "laser power" is equal to or larger than 100, the setting will be "100".
• Marking is not available when the laser power correction value is "0".
• If the corrected value exceeds the setting limit, the nearest upper or lower limit value of the each item is set.
15 Layer No. :
• When more than one condition of the marking data is set, layer No. specifies the marking order.
The laser marker performs the marking with the smaller order of the layer No. specified beforehand (Layer
No. 0 is firstly marked, and Layer No. 15 is marked finally.). Note that it is not applicable for the Step & Repeat
marking.
• In marking connecting character to flying object, layer No. indicates the order of the marking field.
• When the 3D marking mode is selected (only for LP-M and LP-Z series), layer No. indicates in which work
shape is set the condition of the marking data.
Setting Range
* For the setting range of the other model, refer to "Input Setting Value by Series" (P.296).
156
0.100 to 10.000 times
: Sets height and width respectively.
: Sets width with height ratio fixed.
: Sets height with width ratio fixed.
: Sets DXF file size as original size.
0.100 to 120.000 mm (LP-M500 / LP-Z130)*
0.100 to 90.000 mm (LP-S500)*
0.010 to 2.000 mm
0 to 15
ME-LPMSZ-OP-7
0 to 999%
1 to 999%
1 to 999%