Marking To Flying Object - Panasonic LP-M Series Operation Manual

2-12-2 Marking to Flying Object

* This function is not implemented in the LP-SxxxW type
The trigger conditions at marking to flying object are set.
„ Moving Direction
The moving direction of line at marking to flying object is set.
Reference
• The moving direction is common in the all files.
Notice
• In the case of using the function of marking bold character, there might be the possibility that the marking quality is
affected. Therefore, operate the laser marker after performing the marking test using the function of marking bold
character.
• Since the marking to the flying object is affected by vibration or line speed easily, marking and reading 2D code or bar
code to the flying object might become unstable. Therefore, when marking 2D code or bar code to the flying object,
check the marking and reading state of the marked code on the flying object sufficiently.
• Overwriting marking, Step & Repeat marking, point radiation, or Reset at date update functions cannot be used with the
marking to flying object.
• Equidistant marking on the flying object cannot be used in combination with rank marking, external offset, and serial
data marking function.
• In case of LP-M / LP-Z series, the function of Concatenated Marking to Flying Object can not be used in combination
with 3D setting.
• In case of LP-M / LP-Z series, to use the function of Marking to Flying Object in combination with 3D setting, use the
encoder. The marking to flying object without encoder is not available.
• If the rank, external offset, or serial data marking functions are used with the marking to the flying object (excluding the
equidistant marking), make sure that the marking interval time is enough to the required period to input the marking data
and to confirm the marking ready output.
194
LEFT
RIGHT
ME-LPMSZ-OP-7
BACK
FRONT