Table of Contents
Advertisement
Chapter 1: VC7203 Board Features and Operation
Table 1-1: VC7203 Board Feature Descriptions (Cont'd)
Figure 1-2
Reference Designator
Callout
14
SW3
15
DS11
DS2, DS3, DS4, DS5, DS6,
16
DS8, DS9, DS10, DS26,
DS27, DS28, DS29
J199, J200, J201
17
J202, J203 J204
J28, J29, J31, J32, J33,
J34, J35, J36, J37, J40,
18
J104, J105, J106, J107,
J177, J178, J196
19
20
J26
21
J79
22
J121
DS13, DS14, DS15, DS16,
23
DS17, DS18, DS19, DS20
24
SW4, SW5
25
SW2
26
J125
27
JA2
28
JA3
29
JA4
30
J98, J99, J100, J101
31
J141, J142, R233
Power Management
Board 12V Input Power
The VC7203 board receives 12V main power through J2 (callout 3,
12V AC adapter that ships with the board. J2 is a 6-pin (2 x 3), right angle, Mini-Fit
connector.
Caution!
board (Xilinx part number 3800033).
Caution!
ATX connector is not compatible J2 and the board will be damaged if an attempt is made to power it
from a PC ATX power supply connector.
8
Send Feedback
FPGA PROG_B pushbutton,
12V power status LED,
Status LEDS for FPGA logic, transceiver and utility power,
Power regulation jumpers for onboard regulators
External power supply jacks,
GTX transceiver power supply module,
PMBUS connector,
page 12
Connector for USB to UART bridge (mini-B receptacle),
Power connector for active heatsink,
User LEDs (active-High),
User pushbuttons (active-High),
User DIP switches (active-High),
User I/O header,
page 20
FMC1 connector,
page 30
FMC2 connector
page 30
FMC3 connector1
page 30
SMA connectors to differential MRCC pins on FPGA,
Jumpers and potentiometer for XADC reference and analog supply set-up,
page 44
When supplying 12V through J2, use only the power supply provided for use with this
Do NOT use a 6-pin, PC ATX power supply connector with J2. The pinout of the 6-pin, PC
www.xilinx.com
Feature Description
page 17
page 9
page 12
page 13
page 13
page 20
page 21
page 20
VC7203 GTX Transceiver Characterization Board
UG957 (v1.3) October 17, 2014
page 29
page 18
Figure
1-2) using the
Advertisement
Table of Contents
