Virtex-7 Fpga; Fpga Configuration - Xilinx Virtex-7 VC7203 User Manual

Virtex-7 FPGA

The VC7203 board is populated with the Virtex-7 XC7VX485T-3 FFG1761E FPGA at U1
(callout 1,
Overview (DS180)

FPGA Configuration

The FPGA is configured through JTAG using one of the following options:
•
•
•
The VC7203 board comes with an embedded USB-to-JTAG configuration module (U8)
which allows a host computer to access the board JTAG chain using a Standard A to
Micro-B USB cable. Alternately, the FPGA can be configured through the System ACE tool
from an SD memory card installed in J211 (see
DIP Switches, page
JTAG chain using one of the Xilinx configuration cables—Platform Cable USB, Platform
Cable USB II, or Parallel Cable IV (PCIV).
VC7203 GTX Transceiver Characterization Board
UG957 (v1.3) October 17, 2014
Figure 1-2). For further information on Virtex-7 FPGAs, see 7 Series FPGAs
[Ref 4].
USB JTAG connector (callout 5,
System ACE tool SD (callout 7,
JTAG cable connector (callout 6,
17). Finally, a JTAG connector (J7) is available to provide access to the
www.xilinx.com
Figure 1-2)
Figure 1-2)
Figure 1-2)
System ACE Tool SD Configuration Address
Detailed Description
15
Send Feedback