Prog_B Pushbutton; Done Led; Init Led; System Ace Tool Sd Controller - Xilinx Virtex-7 VC7203 User Manual

PROG_B Pushbutton

Pressing the PROG pushbutton SW3 (callout 14,
program pin of the FPGA.

DONE LED

The DONE LED DS21 (callout 12,
FPGA. When the DONE pin is High, DS21 lights indicating the FPGA is successfully
configured.

INIT LED

The dual-color INIT LED DS25 (callout 13,
status. During FPGA initialization the INIT LED illuminates RED. When FPGA
initialization has completed the LED illuminates GREEN.

System ACE Tool SD Controller

The onboard System ACE tool SD controller U32 allows storage of multiple configuration
files on an SD card. These configuration files can be used to program the FPGA. The SD
card connects to the SD card connector J211 (callout 7,
the System ACE SD controller on the back side of the board.

System ACE Tool SD Controller Reset

Pressing the SASD RESET pushbutton SW7 (callout 9,
tool SD controller. The reset pin is an active-Low input.

System ACE Tool SD Configuration Address DIP Switches

DIP switch SW8 shown in
addresses in the SD memory card. A switch is in the ON position if set to the far right and
in the OFF position if set to the far left. The MODE bit (switch position 4) is not used and
can be set either ON or OFF. SW8 is shown in
X-Ref Target - Figure 1-8
VC7203 GTX Transceiver Characterization Board
UG957 (v1.3) October 17, 2014
Figure 1-2) indicates the state of the DONE pin of the
Figure 1-8 selects one of the eight configuration bitstream
SYSACE-2 CFG
SW8
ADR0
ADR1
ADR2
MODE
UG932_c1_08_100712
Figure 1-8: Configuration Address DIP Switch (SW8)
www.xilinx.com
Detailed Description
Figure 1-2) grounds the active-Low
Figure 1-2) indicates the FPGA initialization
Figure 1-2) located directly below
Figure 1-2) resets the System ACE
Figure 1-2 as callout 8.
Send Feedback
17