Transport And Handling; Installation - Orved Evox 31 Hi-Line Operating And Service Manual

14.4 Transport and handling

The appliance can be loaded and unloaded from the transport means using suitable equipment or two persons.
CAUTION!
The vacuum pump contains oil. Always keep the packaging and appliance in a horizontal position to
prevent the oil from leaking out of the pump vent.
All necessary precautions must be adopted when handling the machine to avoid it being damaged, and to avoid
causing injury or damage to persons or property, abiding by the instructions on the packaging.

14.5 installation

1) Check the environmental conditions: room temperature and air exchange. The room temperature of the work-
place must be between 10°C and 35°C. There must be a suitable exchange of air in the place of installation.
2) Check that the electrical specifications indicated on the ID plates correspond with the existing electrical sys-
tem.
3) Place the machine on a flat, stable surface, able to withstand the load.
CAUTION!
• The appliance must be positioned in such a way that it is accessible from all sides.
• Do not obstruct passageways, escape or service routes with the machine. Do not position the appliance in front
of exits or emergency doors.
• Make sure the machine is properly ventilated, leaving a gap of at least 10 cm all around it. The ventilation slots
must be kept free and unobstructed in order to maintain the pump temperature at normal levels.
4) Check the pump oil level.
• Check the correct level through the opening on the rear side, as shown.
• The ideal level corresponds with the centreline of the inspection window.
evox 31
Rev. 02 - 06/2018 - Cod. 1500339 - Vacuum packaging machine user manual
Hi-Line
INSTALLATION
35