Handling And Unpacking; Unpacking; Handling And Storing - Orved n Series Operating And Service Manual

4. HANDLING AND UNPACkING

WARNING!
• Pay particular attention to staples, nails, rivets, sharp edges or anything else that could be a potential
hazard on the packaging. Upon receiving the package, the Customer must verify its integrity, duly
reporting any anomalies, missing items or evident damage to the carrier or transport personnel. In any case, this
report must be made before any other handling or unpacking operation is implemented.
• Any damage on the packaging could result in the machine or its components being damaged. If in doubt about
the actual integrity of the machine following transport, before any other operation, ask your dealer or ORVED
S.p.A. for information.
• The packed machine must be stored in a protected place, which is dry, covered and not exposed to weathering.
The area in question must have a temperature range of 5°C to 40°C and a relative humidity value that does not
exceed 80%. Water and water vapour must be kept at a distance from the installation or storage area.

4.1 UNPACkING

• After having removed the packaging, check the integrity of the machine. If in doubt, do not use the machine and contact
the dealer immediately.
• Store the Velcro strap to tie the power cable to the relative support.
• It is recommended to store the packaging intact for any future handling or storage operations.
• Comply with that described in Chapter 3 for disposal and safety of the packaging material.

4.2 HANDLING AND STORING

WARNING!
• During transport and handling, the machine must always be kept in a horizontal position so as to pre-
vent the oil leaking from the pump.
• Panels must be set in place so as to prevent them from moving inside the vacuum chamber.
• If the machine is stored, the area must be protected, dry, ventilated, covered and not exposed to weathering.
• The area in question must have a temperature range of 5°C to 40°C and a relative humidity value that does not
exceed 80%
• Water and water vapour must be kept at a distance from the installation or storage area.
WARNING!
After having been stored for a long time, perform the following operations:
• The pump oil must be replaced before starting-up, as described in the instructions found in the "MAINTENANCE"
chapter. The oil replacement must be carried out exclusively by authorised and specialised personnel, in com-
pliance with the instructions and the requirements in this manual.
Rev. 08 - 04/2017 - Cod. 1500160 - Instruction manual VGP25N / VGP60N
HANDLING AND UNPACkING
17