Nameplate Data; Transport And Handling; Installation - Orved IDEA 30 User And Maintenance Manual

16.3 Nameplate Data

_______________________________________________________________________________________
ORVED S.P.A Rev.01 – 09/2019 – cod. 1500735-00EN – User Manual for IDEA vacuum packing machines Pag. 60 a 76

16.4 Transport and handling

The appliance can be loaded and unloaded from the transport means using suitable equipment or two
persons.
WARNING! The vacuum pump contains oil. Always keep the packaging and appliance in a
horizontal position to prevent the oil from leaking out of the pump.
All necessary precautions must be adopted when handling the machine to avoid it being
damaged, and to avoid injury or damage to persons or property, abiding by the instructions on
the packaging.

16.5 Installation

1) Check the environmental conditions: room temperature and air exchange.
The room temperature of the workplace must be between +10°C and +35°C. There must be a suitable air
exchange in the installation place.
2) Check that the electrical specifications indicated on the ID plates correspond with the existing electrical
system.
3) Place the machine on a flat, stable surface, able to withstand the load.
WARNING! The appliance must be positioned in such a way that it is accessible from all sides. Do
not obstruct passageways, escape or service routes with the machine. Do not position the
appliance in front of emergency exits or doors.
Make sure the machine is properly ventilated, leaving a gap of at least 10 cm all around it. The
ventilation slots must be kept free and unobstructed in order to maintain the normal pump
temperature.
4) Check the pump oil level.
• Check the correct level through the opening on the rear side, as shown.
• The most recommended level corresponds with the centreline of the inspection window.
WARNING! Never start the machine in case there is no oil in the pump!
_______________________________________________________________________________________
ORVED S.P.A Rev.01 – 09/2019 – cod. 1500735-00EN – User Manual for IDEA vacuum packing machines Pag. 61 a 76