Technical Safety - Orved Evox 31 Hi-Line Operating And Service Manual

SAFETy PRECAUTIONS AND WARNINGS

1.3 Technical safety

• Poorly executed installation and special maintenance or repairs may expose the user to serious
hazards. Ensure these types of works are only performed by qualified personnel authorised by the
manufacturer.
• Pay particular attention to the general conditions of the lid (cracks, chips, scratches and deep dents).
Any damage may cause an implosion with serious implications for the user. Never use the appliance
if the lid is damaged.
• An oil vacuum pump is installed in the appliance. Never tilt or overturn the device to prevent the oil
from overflowing.
• Correct operation of the appliance can only be guaranteed if it is connected to legally compliant
electrical systems, which totally correspond (voltage, frequency) to the data shown on the appliance
data plate. In the case of uncertainty, have the system checked by a qualified electrician.
• Electrical safety can only be guaranteed if the appliance is connected to a compliant earthing system.
Ensure this essential safety condition is satisfied. In the case of uncertainty, have the system checked
by a qualified electrician.
• Power strips or extension cords do not guarantee the required level of safety (fire hazard). Therefore,
do not connect the appliance using these types of devices.
• Touching or altering electrical or mechanical components may result in injury and equipment failure.
Never open the appliance casing.
• If the power cord is damaged, it must be replaced by an authorised service centre.
• When disconnecting the plug, or if the cord is without a plug, make sure the appliance is connected
to the electrical mains by a qualified electrician.
• If anomalies are found in the equipment (for example, the power cord is damaged or the control panel
is not working properly), do not use the machine and promptly inform your authorised service centre.
• Never use the appliance with wet hands or where there is any contact with water.
• The warranty shall be invalidated if the packaging machine is not repaired by an authorised service
centre.
• Only replace any faulty or defective parts with original spare parts supplied by your dealer.
• In the event of a power outage during the vacuum process, the vacuum state is maintained in the
chamber and the lid cannot be opened. Never attempt to open the lid by applying force or using
tools. Once the electrical power is restored, it will be possible to open the lid again.
• When carrying out special maintenance, installation or repair works, disconnect the appliance from
the electrical mains and remove the plug from the outlet. If the plug is not accessible, deactivate the
electrical system to which the appliance is connected via the main switch. Before performing any
repair or installation works, make sure the appliance is effectively disconnected from the mains.
• When the appliance is ready to be scrapped, cut the power cord and and remove the lid to make the
appliance unusable and make it difficult for children to access the inside of the appliance.
4
Rev. 02 - 06/2018 - Cod. 1500339 - Vacuum packaging machine user manual
31
evox
Hi-Line