Table of Contents
Advertisement
134/267
Bosch Rexroth AG
Visualization and engineering interfaces
Fig. 6-1:
Interfaces for HMI connection
The following communication interfaces are supported to communicate with
HMIs (e.g., Rexroth BTV 06 or VEP or VCP), external inputs/outputs or sen‐
sors and a higher-level control unit, but also for communication with
IndraWorks MLD (including VI-Composer, WinStudio):
●
Ethernet interface [note: TCP/IP, FTP (in preparation)]
●
Master communication interface (PROFIBUS, DeviceNet, etc.)
Access to external inputs/outputs or sensors that are connected to the
higher-level control unit via the master communication.
●
Digital and analog inputs/outputs
Access to external inputs/outputs or sensors that are connected to the
drive.
The following hardware requirements are necessary for connecting an opera‐
tor terminal (HMI):
●
Communication interface for connecting an HMI:
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
DOK-INDRV*-MLD3-**VRS*-AP02-EN-P
Rexroth IndraDrive Rexroth IndraMotion MLD (2G) as of MPx-18
Advertisement
Table of Contents
