DOK-INDRV*-MLD3-**VRS*-AP02-EN-P
Rexroth IndraDrive Rexroth IndraMotion MLD (2G) as of MPx-18
6
Visualization and engineering interfaces
6.1
Overview
Supported functions
Interfaces for connecting operator
terminals
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
For visualization and operation of the functions realized with the drive-inte‐
grated PLC, the following options are provided:
●
Reading and writing parameters
●
Reading and writing PLC variables
Apart from Bosch Rexroth operator terminals (HMIs), it is possible
to connect HMIs of other manufacturers to IndraDrive controllers;
this documentation only describes how to connect the HMIs of
Bosch Rexroth.
The figure below contains an overview of the basic possibilities for connect‐
ing HMIs:
Bosch Rexroth AG
Visualization and engineering interfaces
133/267