Table of Contents
Advertisement
DOK-INDRV*-MLD3-**VRS*-AP02-EN-P
Rexroth IndraDrive Rexroth IndraMotion MLD (2G) as of MPx-18
Ethernet interface (TCP/IP)
MLD settings in IndraWorks
Requirements
Settings
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Fig. 7-3:
Communication with the programming interface
At the drive, the Ethernet Engineering Port (HCS01) is used. An Ethernet in‐
terface with TCP/IP protocol is required for communication. The settings of
the TCP/IP communication can be made in IndraWorks via the context menu
of the drive (pertinent parameters: P-0-1531, P-0-1532 and P-0-1533).
The drive should have been fully commissioned before programming MLD.
The settings for the "IndraMotion MLD" function can be configured under the
"MLD" branch. The screenshot below shows the options provided in the
IndraWorks Project Explorer:
Bosch Rexroth AG
Notes on commissioning and application
171/267
Advertisement
Table of Contents
