SECTION - 9
d.
e.
Trim position sender adjustment
ANALOG GAUGES
1. Loosen both trim position sender retaining screws.
IMPORTANT: Do not start the engine during this procedure.
2. Turn ignition key to RUN position.
3. Trim sterndrive unit to the full DOWN/IN position.
90-899883183 DECEMBER 2007
Slowly turn trim limit switch counterclockwise until trim cylinders extend to dimension
shown.
Trim limit switch
a -
Rotate Counterclockwise To Adjust
Alpha trim cylinder extended
a -
Maximum520 mm (20‑3/4 in.)
Retighten screws when adjustment is correct.
b
a -
Retaining screws
PREDELIVERY PREPARATION AND STORAGE
a
7880
a
7881
a
7882
b -
Trim position sender
Page 7 / 24