Checking Transom Input Shaft Bearing Housing (Driveline Models Only) - Mercury Racing 1100 STERNDRIVE Operation, Maintenance & Warranty

6 - M
AINTENANCE
3. If necessary, remove the fill cap and add fluid until the level in
the reservoir reaches the MIN level mark. It is acceptable to fill
the reservoir beyond the MIN level mark, but do not overfill
past the MAX level mark.
Tube
Description
Ref No.
Power Trim
and Steering Trim pump reservoir
114
Fluid
44
15033
Where Used Part No.
92-858074K01
4. Raise the sterndrive unit two or three times to bleed air out of
the system. The fluid level may drop. Add more fluid if
necessary, but do not overfill past the MAX level mark.
5. Replace the fill cap.
C T I S B
HECKING RANSOM NPUT HAFT
O )
NLY
1. Remove the level indication (middle) pipe plug from the input
shaft housing. The gear lubricant level should be to the
bottom of the hole. If not, remove the pipe plug from the top of
the input shaft housing.
2. Fill the input shaft housing through the top pipe plug hole with
fluid until gear lubricant flows from the middle pipe plug hole
(do not overfill).
3. Install the pipe plugs into the input shaft housing and tighten
securely.
a
b
c
21730
H (D M
EARING OUSING RIVELINE ODELS
a - Fill hole
b - Check level here
c - Drain
90-8M0098854 MARCH 2015