Table of Contents
Advertisement
19. Amps Info
20. Oil Levels
21. AIF Info
58
Menu
2 2 . . Press the program button to continue onto Amps Info
reading.
For electric fryers, this display shows the present readings
from the fryers amps sensors, which monitor the electrical
current supplied to the heaters.
On open fryers, these values indicate the current through
each individual heater coil. on 208 or 240 volt units, this
value should be close to the value on the data plate. On
480 volt fryers, this value should be the value on the data
plat multiplied by 1.76.
The "amps" values should normally cook cycle on and off
with the heat on light, and all three values should be about
the same.
Press the program button to continue onto Oil Levels
reading.
Displays the status of the ATO (auto top off) system.
"FULL" or "LOW is displayed depending on the ATO
status. Press the down arrow one time and the display
shows three readings ex. — 1F, L=314, 315. The — 1F is
the difference between
temperature probe if this difference is — 15 degrees or
greater, the vat is low and an "L" is displayed next to this
reading. L=314 is the level sensor reading and 315 is the
main temperature reading in the vat.
Press the program button to continue onto AIF Info.
Information from the AIF (automatic intermittent filtration)
board is available in this step. AIF software is displayed
similar to this format: 20:
1 1 . . Press the down arrow and CPU position 1 of 1
displays
2 2 . . Press down again. INP PAN displays. The control
displays a "" if the drain pan is detected and an "X" if
the drain pan is not detected.
3 3 . . Press down 3 more times and PAD=XXHR FLTRS=0
displays. The XXHR displays how long since the last
filter envelope replacement. Press product button 1.
to view the date of the last filter change and the 2.
product button to view the time of the last filter
Description
the level probe and the
Advertisement
Table of Contents
