Table of Contents
Advertisement
Menu Step
heater problems. The D4: Heating Capacity Report displays the following
information:
•
If the fryer has witnessed two or more low voltage warnings today, the
following report is displayed: "D4: CAN'T TEST" "D4: HEAT
CAPACITY" "D4: DUE TO" "D4: VOLTAGE" "D4: PROBLEMS".
Otherwise, if the assessed heat capacity rating is presently "good" and
at most only one heat-up today that failed to achieve the expected
rate, the following report is displayed: "D4: HEATING" "D4:
CAPACITY" "D4: IS FINE".
•
Otherwise, if the heat capacity is presently assessed as "bad", or
presently assessed as "good" but two or more heat-ups today have not
reached the expected heat-up rate, the following report sequence is
generated: "D4: YOU HAD 75%" "D4: SLOW HEATS" "D4: TODAY".
Press the down button.
•
"D4: HAVE 20%" "D4: SLOW HEATS" "D4: THIS OIL". Press the down
button.
•
"D4: HAD 0%" "D4: SLOW HEATS" "D4: LAST OIL". Press the down
button.
•
If the heat capacity is assessed as bad (low heat-up rate on last heat-
up, and on three of the last four heat-ups), then the heating coils are
suspect and the following is displayed: "D4: CHECK COILS," "D4:
CONTACTORS," "D4: AND WIRING". Otherwise, the heating coils are
presumed to be good and the following messages appear: "D4:
HEATER COILS" "D4: APPEAR OK". Press the down button.
•
"D4: CHECK" "D4: CONTACTORS," "D4: CONNECTIONS," "D4: AND
WIRING"
D5: Cook
This summarizes the "slow cooking" status for each product. Actual cook
Times (Slow
times for cook cycles can vary from the programmed cook time setting,
Cooks) Report
due to the load compensation feature. Load compensation slows the cook
timer down when the actual oil temperature is below a reference value,
and speeds up the cook timer countdown when oil temperature is above
the reference. When the oil temperature is lower than expected during a
cook cycle, the overall cook time will be longer than normal. The D5: Cook
Times Report contains the following information:
•
If the actual cook time stretches beyond a programmed limit, the
controller counts a "SLOW COOK" event and sounds an alarm at the
end of the cook cycle.
Description
71
Advertisement
Table of Contents
