Table of Contents
Advertisement
3 3 . . 6 6 . . 3 3 F F i i l l l l F F r r o o m m P P a a n n
"FILL FROM PAN" pumps oil from the drain pan back up to the vat. This step can be
helpful to troubleshoot whether the filter pump motor runs, or to ensure that all oil is
pumped out of the drain pan if the pan is to be removed from the fryer.
Press and hold the either filter button until display shows "*FILTER MENU*"
1 1 ) )
followed by "1.EXPRESS FILTER".
Press the down button four times until "5. FILL FROM PAN" shows in display.
2 2 ) )
Press product selection 1; "FILL" & "DONE" is displayed.
3 3 ) )
Press the left timer button; display shows "FILLING" and oil is pumped from the
4 4 ) )
drain pan to the vat. Stop the pump by pressing the left timer button again.
3 3 . . 6 6 . . 4 4 F F i i l l l l F F r r o o m m R R e e s s e e r r v v e e O O i i l l T T a a n n k k
If oil level is a little low, oil can be added to vat at any time from reserve oil tank to
raise oil level to proper level by following steps below. This procedure is n n o o t t to be
used to fill an empty vat.
Press and hold the either filter button until display shows "*FILTER MENU*"
1 1 ) )
followed by "1.EXPRESS FILTER".
Press the down button five times until "6.FILL FRM RESRV" shows in display.
2 2 ) )
Press product selection 1; "FILL" & "DONE" is displayed.
3 3 ) )
Press and hold left timer button; display shows "FILLING" and oil is pumped
4 4 ) )
from the reserve oil tank to the vat.
Once vat is full, release the timer button; "FILL" & "DONE" displays. Press the
5 5 ) )
right timer button and then product selection 3 for normal operation.
3 3 . . 7 7 D D r r a a i i n n P P a a n n A A s s s s e e m m b b l l y y
Remove and clean the drain pan assembly at the end of the night. The drain pan
should be clean prior to closing. Assemble the clean, dry drain pan using the following
instructions:
Slide a filter envelope (3) onto the filter screen (2) so the plug is protruding
1 1 ) )
through the hole, see to
B B e e s s t t P P r r a a c c t t i i c c e e : : During assembly, be sure to apply new oil to all o-rings to lubricate to
help prevent tears and damage. See
page
38.
Fold the open end of the filter envelope inward, then fold the end down to seal
2 2 ) )
off the opening, see detail A.
Slide the two handle clamps (1) onto the ends of the filter screen assembly with
3 3 ) )
the handles facing the same direction of the plug.
Figure 3-6 Filter Envelope Installation , page
4.2.3 Quarterly Drain Pan O-Ring Replacement ,
30.
29
Advertisement
Table of Contents
