Table of Contents
Advertisement
Item
No.
P14
*
*
*
*
*
14
Description
LED Outputs
Current Sensor
Main Power Switch
Temp. Probe
USB Connection
Wi-Fi Connection
*Unnumbered on Decal
Functions
- HI: Hi Limit Contactor
- RH: Heat Contactor
Full vat LED filter beacon:
-14 ma. limit; White +/ Black -
Used on Chick-fil-A units only to measure
AMPs. Wires have a ferrite ring around the to
prevent radio wave interference.
Incoming voltage (P2 to P1) is stepped down to
24V, and then from the control panel to the
power switch. Based on the position of the
switch:
- OFF: Allows limited access to control panel
menus but no access to fryer functions.
- ON: Allows full access to all fryer functions
and control panel menus.
Position 1 - 12, upper left to lower right:
1 1 . . Not Used
2 2 . . Not Used
3 3 . . Temperature Probe
4 4 . . Temperature Probe
5 5 . . Not Used
6 6 . . Not Used
7 7 . . Protection Probe
8 8 . . Protection Probe
9 9 . . Not Used
1 1 0 0 . . Not Used
1 1 1 1 . . Top off temperature probe
1 1 2 2 . . Top off temperature probe
Used to manually flash firmware or load
software directly on to the control panel.
Used to connect the power cable from the
control panel to the radio, and the data cable
from the radio to the control panel.
Advertisement
Table of Contents
