Table of Contents
Advertisement
Note the location of the wire connections, and then compare them to the wiring
2 2 ) )
diagram on the pump motor's data plate.
Ensure the wires are connected according to the application requirement. If not,
3 3 ) )
use the wiring diagram on the motor's date plate to change the wiring as
applicable.
Leave the wiring cover plate off so power wires can be attached later in the
4 4 ) )
installation.
9 9 . . 1 1 3 3 . . 3 3 M M i i g g r r a a t t e e a a n n O O l l d d F F i i l l t t e e r r P P u u m m p p t t o o a a N N e e w w F F i i l l t t e e r r M M o o t t o o r r
The filter pump attaches to the end of the filter motor. These instructions also include
the seal and the roller kit replacement procedures. Refer to
Plumbing Components , page 154
• If an old filter pump is being reused on a new filter motor, order and install seal kit
17476 on the new filter motor. Also, replace the old rollers and o-ring in the old filter
pump with 17446.
• If the entire filter pump and motor assembly is being replaced, continue to
Filter Pump/Motor Installation , page
9 9 . . 1 1 3 3 . . 3 3 . . 1 1 R R e e m m o o v v e e t t h h e e F F i i l l t t e e r r P P u u m m p p
With the old filter pump and motor on a flat sturdy work surface, do the following:
Remove the two screws connecting the filter pump to the face of the filter motor.
1 1 ) )
Separate the pump and motor assemblies.
2 2 ) )
9 9 . . 1 1 3 3 . . 3 3 . . 2 2 I I n n s s t t a a l l l l t t h h e e F F i i l l t t e e r r M M o o t t o o r r S S e e a a l l K K i i t t
The oil seals prevent oil from migrating into the motor assembly. With the new filter
motor on a flat sturdy work surface, using seal kit 17476, install the pump seal
components on to the new filter pump motor as shown in
Placement , page
118.
for location, illustration and part numbers.
119.
Figure 9-3 Pump Seal Kit
Figure 10-7 Motors and
9.13.4
117
Advertisement
Table of Contents
