Local Serial Upgrade Using Wipconfig - Airspan ASWipLL Commissioning Manual

U p g r a d i n g AS W i p L L D e vi c e s

27.3. Local Serial Upgrade using WipConfig

You can perform local serial software version upgrades by connecting a PC running
WipConfig to the ASWipLL device. Upgrades through a serial configuration are
required when installing the devices and before a BSR-SPR air link is established.
For a detailed explanation on the serial cable setup, refer to the ASWipLL Hardware
Installation Guide.
The following procedure provides an example of upgrading an SPR (10.0.0.20) from
SW version 2.96.000.001 to 2.97.000.002 using WipConfig.
To upgrade a device's SW version (e.g. SPR):
1. Connect the PC (i.e. serial port) running WipConfig to the ASWipLL device, and
ensure that the ASWipLL device remains connected to the ASWipLL Ethernet
switch/hub (i.e. SDA or BSDU).
2. Start WipConfig, and then connect WipConfig to the ASWipLL device by
selecting Serial, and then clicking the Connect button.
27-20 Airspan Networks Inc.
C o m m i s s i o n i n g M a n u a l
01040311-07