Task 9: Test The Bsr-Spr Network Link - Airspan ASWipLL Commissioning Manual

E s t a b l i s h i n g B S R - S P R L i n k i n B r i d g e M o d e

5.10. Task 9: Test the BSR-SPR Network Link

You can test the link between the BSR and SPR by pinging the SPR from a PC
located behind the BSR.
To test the link by pinging:
From the PC/Laptop (IP address 10.0.0.2) behind the BSR, open an MS-DOS
prompt and use the
10.0.0.11), as shown below:
Figure 5-28: Pinging the ASWipLL device using the MS-DOS ping-t command
Note: To ping devices in the transparent bridging mode, all devices (including
hosts) must be in the same subnet.
5-26
command to ping the SPR (IP address
ping – t
Airspan Networks Inc.
C o m m i s s i o n i n g M a n u a l
01040311-07