Airspan ASWipLL Commissioning Manual page 168

C h a n g i n g L i n k f r o m R o u t e r t o B r i d g e
5. Apply factory default settings by performing the following:
a. On the toolbar, click the Set Factory Default
A Warning message box appears.
Figure 6-5: Warning message box for setting defaults
b. Click Yes to confirm applying factory defaults to the device.
A Warning message box appears, requesting you to confirm device reset.
Figure 6-6: Warning message box for resetting device
c. Click Yes to reset the device with default settings.
6. From the Mode drop-down list, select Bridge (i.e. transparent bridging).
Note: If in the BSR's ROM, the BSR is defined as an IP router, then the Mode
field displays Router; If the BSR is defined for transparent bridging, then the
Mode field displays Bridge.
7. In the Eth IP Address field, enter the BSR's IP address (e.g. 10.0.0.10).
8. In the Eth Subnet Mask field, enter the BSR's subnet mask address (e.g.
255.255.255.240).
6-8 Airspan Networks Inc.
C o m m i s s i o n i n g M a n u a l
button.
01040311-07