Table of Contents
Advertisement
Section 6
To select Datalogger Event items:
To access the [Datalogger Events] option list press the <Right Arrow>.
Move cursor to desired item press the <Up/Down Arrow> then <ENTER> to select it.
Note that a plus sign (+) appears before the item.
To de-select Datalogger Events:
Move the cursor to the item by pressing the <Up/Down Arrow> then <ENTER>.
Note that this removes the plus sign (+) from the item.
After selecting all desired items press the <Left Arrow> to leave the [Datalogger Events] option
list.
Important point about Datalogger resources and dual-channel systems.
When logging data on both measurement channels simultaneously, the Datalogger stores reports in a
single common file. It is important that you select Site ID to appear on each line of data so that you can
always identify which channel generated each report.
6.9
THE I/O DATA CONTROL MENU
This menu becomes available after picking a Meter Type and Channel. Use this menu to assign func-
tions for the meter's analog outputs and optional inputs. The Analog Out Setup assigns functions to
the meter's current, voltage and pulse rate outputs. Each menu cell presents an option list of the
available data items. In addition, you can set up the alarm relays, enable and span the analog input
ports.
Use this menu to
assign data functions
to analog outputs.
Use this menu to assign
alarm functions to relay
outputs.
Siemens
2 Channel [1]
Assign Data to Analog Outputs
Analog Out Setup
Relay Setup
I/O Data Control
6-50
Channel 1
1020NFM-1D
Advertisement
Table of Contents
