The Meter Facilities Menu - Siemens SITRANS FUS1020 Manual

Section 6
6.10

THE METER FACILITIES MENU

Meter Facilities functions are available immediately after unit startup by pressing the <ENTER> key.
The Meter Facilities menu provides global control that enables you to identify and activate the following
functions and features of the hardware supported by this model. See Section 5 for menu structure.
Select data entry and meter output in either English (default) or metric units.
Customize the default pipe and transducer tables to suit your requirements.
Output, display, erase and select a memory management method for the Datalogger.
Determine the amount of memory available.
Verify/Adjust the analog output voltage and current using a multimeter.
Verify/Adjust the analog pulse output using a frequency counter.
Set the system clock/calendar.
Obtain detailed software/hardware identification.
This menu allows you
to specify default
measurement units.
This menu allows you
to create or edit pipe
and transducer tables.
This menu allows you
to work with and
select a Datalogger
storage method.
This menu allows you
to set the system
clock/calendar.
Siemens Dual Path
Select Default Units for all Menus
Preferred Units
Table Setups
Datalogger Cntrl
Memory Control
Analog Output Trim
Clock Set
RS-232 Setup
System Info
Meter Facilities
This menu shows detailed information
about this model's hardware and software.
6-53
SITE 1
English
09.02.99 09.30.06
38400 Odd 7
1020NFM-1D
This menu allows
you to view the
number of data
memory bytes.
This menu allows
you to fine-tune the
analog outputs.
This menu allows you
to select RS-232 port
parameters.