Table of Contents
Advertisement
Section 2
Pressing the <Right Arrow> changes the left-hand column to [Relay 1]. Pressing the <Right Arrow>
again accesses the option list. This expands the highlighted area to show the contents of the list. Note
that a "greater than" symbol (>) points to the top item on the list.
The <Up and Down Arrows> allow you to scroll the option lists. Every key press sequentially moves the
cursor to the next item. Due to the size of the display screen, some option lists include more items than
the display can show. For example, on the screen above the last option shown is [Batch Tot]. However,
this option list has more listings. Continue to press the <Down Arrow> to see more Relay selections.
When you arrive at the last item on a list, the next <Down Arrow> press brings you back to the top of the
list. This is because the option lists are of the "wrap-around" type.
To select an option list item, move the cursor to the item and then press the <ENTER> key.This places
your selection at the top of the list and moves you out of the option list to the next menu cell. Examine
the screen below. The option list item: [Fault Alarm] has been selected and appears in the right-hand
column.
NOTE: The selected option list menu cell appears in the right-hand column and the high-
lighted area moves to the next menu cell in the menu sequence: [Relay 2], if available.
Siemens
Channel
Select a function for Relay 1
Relay 1
ens
Relay Setup
Siemens
2 Channel
Select a function for Relay 2
Relay 1
Relay 2
Relay Setup
2-23
[1]
SITE1
>Off
Power On
High Flow
Low Flow
Flow Alarm
Fault Alarm
Spacing
Empty
Aeration
Interface
Reverse Flow
Batch Tot
[1]
SITE1
Fault Alarm
Off
1020NFM-1D
Advertisement
Table of Contents
