The I/O Data Control Menu - Siemens SITRANS F Instruction Manual

Section 2
To enable the on-screen datalogger display:
To access the [Display Datalogger] option list press
To move the cursor to the desired function press
To invoke the function press
To scroll the on-screen datalogger display:
To display one line at a time press
+
Use key to scroll down one screen (10 lines) at a time.
Use = key to jump to 15 lines of the last screen.
In No Line Wrap mode:
Use or
to scroll 8 columns to the right or the left. To get out of the display, press
NOTE: In single channel 1010 units the Datalogger uses a compression scheme that precludes
backward scrolling.
Important point about Datalogger resources and dual-channel systems.
When logging data on both measurement channels simultaneously, the Datalogger stores re-
ports in a single common file. It is important that you select Site ID to appear on each line of
data so that you can always identify which channel generated report.

2.10 THE I/O DATA CONTROL MENU

This menu becomes available after picking a Meter Type and Channel. Use this menu to assign functions
for the meter's analog outputs and optional inputs. The Analog Out Setup assigns functions to the meter's
current, voltage and pulse rate outputs. Each menu cell presents an option list of the available data
items. In addition, you can set up the alarm relays, enable and span the analog input ports.
Use this menu to
assign data functions
to analog outputs.
Use this menu to
assign alarm
functions to relay
outputs.
ENT
to scroll one column to the left or right. Use
Siemens
Assign Data to Analog Outputs
Analog Out Setup
Relay Setup
Analog Input Setup
I/O Data Control
ALT
Dual Path SITE1
2-60
1010ENFM-3B
+ or +
ALT
.
MENU
Use this menu to enable
and span optional
analog inputs.