Buttons And Dip Switches - Pepperl+Fuchs WHA-GW Manual

WHA-GW-*
Operation
LED indicators
LED flashes
LED off
6.1.2

Buttons and DIP switches

Figure 6.3Buttons inside the gateway housing
1 Button A
2 Button B
Time pressed
Function of button A
> 3 seconds
Function of button B
> 3 seconds
Function of button [A + B] (security mode disabled)
> 3 seconds
66
A HART or MODBUS message is received by the gateway via the
Ethernet interface. The LED does not flash if the message is not
addressed to the gateway or if a communication error was
detected within the message..
No Ethernet communication at present.
Function
Configuration reset: This button sets all gateway configuration
parameters back to factory settings with exeption of the
parameters set by button B and button A + B.
After 3 seconds, all LEDs light up to confirm the reset.
Communication reset: This button sets all gateway configuration
parameters related to the wired communication channels back to
factory settings.
After 3 seconds, all LEDs light up to confirm the reset.
Password reset: When pressed while the Security Mode is
disabled (see Figure 6.4 on page 67), the buttons set the
password used to access the web server (HTTPS password) back
to factory settings. The factory default password for the web server
(HTTPS) is "admin".
After 3 seconds, all LEDs light up to confirm the reset.