Buttons - Pepperl+Fuchs VBG-PN-K30-DMD-S16-EV Manual

AS-i 3.0 PROFINET Gateway with integr. Safety Monitor
Electrical connection
9.10.3

Buttons

The buttons are used for the following:
⇑
Mode/
Switching between configuration mode and protected operating mode, and saving
the current AS-i configuration as the nominal configuration.
Set/⇓
Selecting the address of and assigning an address to a slave.
OK
Change to extended mode.
ESC/Service
For teaching the code table for a new safe slave, when exactly one safe slave is
being replaced, and for unlocking the Safety Monitor. This button is also used to exit
extended mode.
For additional information see:
• <Section <Function of the ESC/Service key>
• <Section <Replacing a defective safety-configured AS-i slave>
• <Section <Operation in advanced display mode>.
60