Installing The Control Panel-8 Hard Drive System - Dell EMC PowerEdge R620 Owner's Manual

Figure 55. Removing and installing the control panel
1 control panel
2 notches on chassis front wall
3 display module ZIF connector
4 display module cable
5 screw
Installing the control panel—8 hard drive system
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Slide the left side of the control panel into the chassis so that the left tab on the control panel aligns with the slot on the chassis wall
and the top left tab aligns with the slot on the top of the chassis.
2 Pull the display module cable through the opening and into the chassis.
3 Push the right side of the control panel until the top right tab aligns with the top of the chassis and the panel snaps into place.
4 Using a #1 Philips screwdriver, replace the screw (located at the bottom of the chassis) that secures the control module to the
chassis.
CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab on the
connector is released before removal and insertion. The locking tab must be engaged after insertion.
5 Connect the display module cable to the control panel board.
6 Close the system.
7 If applicable, install the front bezel.
8 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Installing and removing system components 89