Installing The Integrated Storage Controller; Network Daughter Card; Removing The Network Daughter Card - Dell EMC PowerEdge R620 Owner's Manual

Installing the integrated storage controller

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2 Open the system.
3 Align one end of the card with the card holder on the system board.
4 Lower the other end of the card and align the holes on the card with the locating posts of the extractors on the system board.
5 Press the card down at the corners until it is fully seated.
When the card is fully seated, the plastic standoff tab snaps over the edge of the holder.
6 Close the system.
7 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Network daughter card

Removing the network daughter card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2 Open the system.
3 Remove the expansion-card riser 3.
4 Using a #2 Phillips screwdriver, loosen the two captive screws that secure the network daughter card to the system board.
5 Hold the network daughter card by the edges on either side of the touch point and lift to remove it from the connector on the system
board.
6 Slide the network daughter card away from the back of the system until the RJ-45 connectors are clear of the slot in the back panel.
7 Lift the network daughter card out of the system.
66 Installing and removing system components