Installing An Expansion Card - Dell EMC PowerEdge R620 Owner's Manual

Figure 27. Removing and installing the expansion card
1 expansion card
3 expansion-card latch

Installing an expansion card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: The expansion card riser 1 and the x16 link on the riser 2 slot can be used only when both the processors are installed.
1 Remove the expansion card riser.
1 Unpack the expansion card and prepare it for installation.
For instructions, see the documentation that accompanied the card.
2 Locate the expansion card connector on the system board or riser.
3 Open the expansion card latch and remove the filler bracket.
4 Holding the card by its edges, position the card so that the card edge connector aligns with the expansion card connector.
5 Insert the card edge connector firmly into the expansion card connector until the card is fully seated.
6 Slide the expansion card latch into position.
58 Installing and removing system components
2 expansion-card connector