Boot Settings Screen; Integrated Devices Screen - Dell EMC PowerEdge R620 Owner's Manual

Boot Settings screen

Menu item Description
Boot Mode Allows you to set the boot mode of the system.
If the operating system supports UEFI, you can set this option to UEFI. Setting this field to BIOS allows
compatibility with non-UEFI operating systems. By default, the Boot Mode option is set to BIOS.
Boot Sequence Allows you to enable or disable the boot sequence retry feature. If this field is enabled and the system fails to boot,
Retry the system reattempts the boot sequence after 30 seconds. By default, the Boot Sequence Retry option is set to
Disabled.
BIOS Boot Settings Allows you to enable or disable BIOS Boot options.
UEFI Boot Settings Allows you to enable or disable UEFI Boot options. The Boot options include IPv4 PXE and IPv6 PXE. By default,
the UEFI PXE boot protocol is set to IPv4.
One-Time Boot Allows you to enable or disable a one-time boot from a selected device.

Integrated devices screen

Menu Item Description
Integrated RAID Allows you to enable or disable the integrated RAID controller. By default, the Integrated RAID Controller option is
Controller set to Enabled.
User Accessible USB Allows you enable or disable the user accessible USB ports. Selecting Only Back Ports On disables the front USB
Ports ports and selecting All Ports Off disables both front and back USB ports. By default, the User Accessible USB
Ports option is set to All Ports On.
Internal USB Port Allows you to enable or disable the internal USB port. By default, the Internal USB Port option is set to On.
Internal SD Card Enables or disables the system's internal SD card port. By default, Internal SD Card Port option is set to On.
Port
Internal SD Card If set to Mirror mode, data is written on both SD cards. If any one of the SD card fails, data is written to the active
Redundancy SD card. Data from this card is copied to the replacement SD card at the next boot. By default, Internal SD Card
Redundancy option is set to Mirror.
Integrated Network Allows you to enable or disable the integrated network card 1. By default, the Integrated Network Card 1 option is
Card 1 set to Enabled.
CAUTION: Switching the boot mode may prevent the system from booting if the operating system is not
installed in the same boot mode.
NOTE: Setting this field to UEFI disables BIOS Boot Settings menu. Setting this field to BIOS disables
the UEFI Boot Settings menu.
NOTE: This option is enabled only if the boot mode is BIOS.
NOTE: This option is enabled only if the boot mode is UEFI.
NOTE: This option is displayed only if IDSDM is installed on the system board.
NOTE: This option is displayed only if IDSDM is installed on the system board.
Using the system setup and boot manager 25