Removing The Integrated Storage Controller - Dell EMC PowerEdge R620 Owner's Manual

Removing the integrated storage controller

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2 Open the system.
3 Push down on the two tabs at the edge of the card and lift the card off the extractors.
As the card releases from the standoffs, the connector under the card disengages from the system board connector.
4 Angle the card so that the other end of the card disengages from the storage-controller card holder on the system board.
5 Close the system.
Figure 33. Removing the integrated storage controller
1 storage connector on the system board
2 storage controller card
3 storage-controller card holder
4 extractors (2)
Installing and removing system components 65