Dell EMC PowerEdge R620 Owner's Manual page 128

Table of Contents

Advertisement

Error Code
Message Information
Details
Action
SEC0033
Message
LCD Message
Details
Action
SEL0006
Message
Details
Action
SEL0008
Message
Details
Action
SEL0012
Message
Details
Action
SEL1204
Message
LCD Message
Details
Action
TMP0118
Message
LCD Message
Details
Action
TMP0119
Message
LCD Message
128
System messages
The chassis is open. System performance may be degraded, and security may be
compromised.
Close the chassis. Check system logs.
The chassis is open while the power is off.
Intrusion detected. Check chassis cover.
The chassis was opened while the power was off. System security may have been
compromised.
Close the chassis and verify hardware inventory. Check system logs.
All event logging is disabled.
This message is displayed when all event logging has been disabled by the user.
If unintended, re-enable logging.
Log is full.
When the event log is full, additional events are not written to the log. Older events may
be overwritten and lost. This message may also appear if the user disabled event logging.
Backup and clear log.
Could not create or initialize the system event log.
If the system event log fails to initialize, platform status and failure events are not
captured. Some management software do not report platform exceptions.
Reboot the management controller or iDRAC. Cycle system input power. If problem
persists call support.
An unknown system hardware failure detected.
Unknown system hardware failure.
If the system event log failed to initialize, platform status and failure events are not
captured. Some management software do not report platform exceptions.
Re-configure system to the minimum supported configuration. If issues persists, contact
support.
The system inlet temperature is less than the lower warning threshold.
System inlet temperature is outside of range.
Ambient air temperature is too cool.
Check the system operating environment.
The system inlet temperature is less than the lower critical threshold.
System inlet temperature is outside of range.

Advertisement

Table of Contents
loading

Table of Contents