Back-Panel Features And Indicators - Dell EMC PowerEdge R620 Owner's Manual

Back-panel features and indicators

Figure 5. Back-panel features and indicators—8 hard drive system (2 pcie expansion cards)
Item Indicator, Button, or Connector Icon
1 System identification button
2 System identification connector
3 iDRAC7 Enterprise port
4 Serial connector
5 PCIe expansion card slot (riser 2)
6 Video connector
7 USB connectors (2)
8 Ethernet connectors (4)
9 PCIe expansion card slot (riser 3)
10 Power supply (PSU1)
11 Power supply (PSU2)
14 About your system
Description
The identification buttons on the front and back panels can be used
to locate a particular system within a rack. When one of these
buttons is pressed, the LCD panel on the front and the system
status indicator on the back blink until one of the buttons is pressed
again.
Press to toggle the system ID on and off. If the system stops
responding during POST, press and hold the system ID button for
more than five seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup) press and hold
for more than 15 seconds.
Allows you to connect the optional system status indicator
assembly through the optional cable management arm.
Dedicated management port.
NOTE: The port is available for use only if the iDRAC7
Enterprise license is installed on your system.
Allows you to connect a serial device to the system.
Allows you to connect a PCIe expansion card.
Allows you to connect a VGA display to the system.
Allows you to connect USB devices to the system. The ports are
USB 2.0-compliant.
Four integrated 10/100/1000 Mbps NIC connectors
or
Four integrated connectors:
• Two integrated 10/100/1000 Mbps NIC connectors
• Two integrated 100 Mbps/1 Gbps/10 Gbps SFP+ connectors
Allows you to connect a PCIe expansion card.
AC 495 W, 750 W, or 1100 W
Or
DC 750 W or 1100 W