Internal Dual Sd Module (Optional); Removing The Internal Dual Sd Module - Dell EMC PowerEdge R620 Owner's Manual

Internal dual SD module (optional)

The Internal Dual SD Module (IDSDM) card provides two SD card slots. This card offers the following features:
• Dual card operation — maintains a mirrored configuration by using SD cards in both the slots and provides redundancy.
NOTE: When the Redundancy option is set to Mirror Mode in the Integrated Devices screen of System Setup, the information
is replicated from one SD card to another.
• Single card operation — single card operation is supported, but without redundancy.

Removing the internal dual SD module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
2 Open the system.
3 Locate the internal dual SD module installed on the J_RIPS connector on the system board.
4 If applicable, remove the SD card(s).
5 Holding the tab, pull the dual SD module to remove it from the system board.
6 Close the system.
7 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
62 Installing and removing system components