Removing The Air Duct - Huawei FusionServer Pro XH321 V5 V100R005 Maintenance And Service Manual

FusionServer Pro XH321 V5 Server Node
Maintenance and Service Guide
Step 9 Install the PCIe riser modules.
1.
2.
3.
4.
Figure 8-64 Installing the PCIe riser module
Step 10 Install the server node.
For details, see
Step 11 Power on the server node.
For details, see
----End

8.4.23 Removing the Air Duct

Procedure
Step 1 Power off the server node.
For details, see
Issue 07 (2019-12-20)
This operation is required only when the PCIe card is an SP380 NIC (BOM code: 02312JBD).
Insert the PCIe riser module into the front PCIe slot of the server node in the
arrow direction. See (2) in
Use a Phillips screwdriver to tighten the screw to secure the PCIe riser module.
See (3) in Figure 8-64.
Install the server node panel in the arrow direction. See (4) in
Use a Phillips screwdriver to tighten the screws on the node panel. See (5) in
Figure 8-64.
8.3.4 Installing an XH321
8.3.1 Power-On
8.3.2 Power-Off
Copyright © Huawei Technologies Co., Ltd.
Figure 8-64.
V5.
Procedure.
Procedure.
8 Parts Replacement
Figure 8-64.
96