Huawei FusionServer Pro XH321 V5 V100R005 Maintenance And Service Manual page 76

FusionServer Pro XH321 V5 Server Node
Maintenance and Service Guide
Figure 8-32 Positions of processors
Step 6 Remove the conjoined heat sink and processor carrier.
1.
2.
3.
4.
5.
Issue 07 (2019-12-20)
Use a Phillips screwdriver to loosen the four screws (marked 2 in the label) in
the middle of the heat sink in a diagonal sequence. See (1) in
Use a Phillips screwdriver to loosen the two diagonal screws (marked 1 in the
label) on the heat sink. See (2) in
Lift the heat sink and place it upside down on the ESD desk.
Insert a flat-head screwdriver into the groove of the processor carrier, and
twist it to pry up one side of the carrier. See (3) in
Insert only the tip of the flat-head screwdriver. Do not apply excessive force.
Holding the other end of the carrier, remove the carrier and processor in the
arrow direction. See (4) and (5) in
Copyright © Huawei Technologies Co., Ltd.
Figure 8-33.
Figure
Figure 8-33.
8 Parts Replacement
Figure 8-33.
8-33.
68