Installation Positions; Processor - Huawei FusionServer Pro XH321 V5 V100R005 Maintenance And Service Manual

FusionServer Pro XH321 V5 Server Node
Maintenance and Service Guide
Table 2-3 LOM ports
Chip Model
X722
● Use
● The LOM ports do not support forced rates.
● The electrical LOM ports cannot be connected to power over Ethernet (PoE)
● The electrical LOM ports do not support SR-IOV.
● Forcibly powering off a server will cause intermittent NC-SI disconnection

2.1.4 Installation Positions

An X6000 can house a maximum of four XH321 V5 nodes in a 2U chassis.
Figure 2-5 Installation positions

2.2 Processor

●
●
●
Issue 07 (2019-12-20)
Port Type
10GE optical
port
GE electrical
port
Intelligent Computing Compatibility Checker
about the cables and optical modules supported by the LOM ports.
devices (such as a switch with PoE enabled). Connecting a LOM port to a PoE
device may cause link communication failure or even damage the NIC.
and disable the Wake on LAN (WOL) function of the LOM ports. To restore
the NC-SI connection, refresh the iBMC WebUI.
The server supports one or two processors.
If only one processor is required:
– Install it in socket CPU1.
– NVMe SSDs are not supported.
The processor heat sink varies depending on the processor power:
– If the maximum processor power is 165 W, use a narrow conjoined heat
sink.
Copyright © Huawei Technologies Co., Ltd.
Rate Supported
Negotiation Rates
Mode
Auto- 10000M
negotiation
10000 Mbit/s
(full duplex)
Auto- 1000M
negotiation
1000 Mbit/s
(full duplex)
2 Hardware Description
Rates Not
Supported
10/100/1000
M
10/100M
to obtain information
11