Tray Motor Replacement - Ricoh FT8680 Service Manual

31 July 1995

6.6 TRAY MOTOR REPLACEMENT

[A]
[B]
1. Remove the upper and rear covers.
2. Disconnect the 6P connector [A] of the tray motor and remove the 3
screws [B].
3. Turn the tray motor [C] so that the connecting shafts [D] are horizontal.
NOTE: Hold the tray bottom plate during the following step to prevent the
bottom plate from falling down.
4. Remove the tray motor with the bracket by sliding it to the left (see
illustration) so that the connecting shafts are disconnected.
5. Remove the tray motor [E] (2 harness clamps and 4 screws) from the
bracket.
[D]
[C]
A171R588.img
5-59
LCT
[E]
A171R605.img