Entrance Guide Height Adjustment - Ricoh FT8680 Service Manual

31 July 1995

9.8 ENTRANCE GUIDE HEIGHT ADJUSTMENT

[B]
[C]
[A]
NOTE: Normally the entrance guide is set in the lowest position tightened by
the two screws in the lowest holes. Set it in the middle position or top
position if paper creasing occurs.
1. Pull out the fusing unit.
2. Remove the two screws [A] from lowest holes [B].
3. Insert the two screws [C] into the middle or top holes [D].
4. Slide up the entrance guide [D] to the middle or top position.
5. Tighten the two screws [A]
[D]
[C] [B]
5-89
IMAGE FUSING
A171R527.img