Ricoh FT8680 Service Manual page 279

AROUND THE DRUM
[H]
[I]
[E]
[G]
[B]
6. Remove the paper guides [A].
7. Remove the front end block cover [B] and the rear end block cover [C].
8. Unhook the tension springs [D] and remove the corona wires [E].
9. Remove the cleaner pads [F].
10. Clean the unit casing and end block.
NOTE: Use water first and then use alcohol to remove toner remaining
on the unit.
11. Install the new wires with the damper rings [G] and new cleaner pads.
12. Reassemble.
NOTE: Note that two kinds of tension spring are used. The hooks of the
spring differ as shown. [H] is for the transfer corona and [I] is for
the separation corona.
[C]
[D]
[A]
A171R585.img
5-50
31 July 1995
[F]
A171R596.img