Ricoh FT8680 Service Manual page 336

31 July 1995
12.4 FEED-IN MOTOR REPLACEMENT
[L]
[E]
1. Remove the original feed unit.
2. Remove the rear under cover [A] (4 screws).
3. Remove the DF main board [B] (3 screws and 8 connectors) and
disconnect the 2 connectors [C] of the feed-in motor [D].
4. Mark the tension bracket [E] position, loosen the screw [F] and remove
the screw [G]. Remove the timing belt [H].
5. Remove the relay roller pulley [I] (1 E- ring).
6. Remove the pick-up roller home position sensor [J] (1 screw and 1
connector).
7. Remove the rear side plate [K] (6 screws).
8. Remove the tension bracket [E] (2 screws).
9. Replace the feed-in motor [L] (4 screws).
[C]
[D]
[B]
[A]
[K]
A171R663,img
5-107
[G]
[J]
[E]
ARDF
[I]
[H]
[F]
A171R662.img