Dip Switch Table - Ricoh FT8680 Service Manual

31 July 1995

3. DIP SWITCH TABLE

3.1 MAIN PCB
#1 #2
OFF OFF
ON OFF
ON ON
OFF ON
#3 #4
OFF OFF
ON OFF
OFF ON
ON ON
NOTE: The Machine only detects DIP switch positions just after the main
switch is turned on.
3.2 RESET SWITCH PCB
#
1 SC reset (after solving the problem)
2 Not used
Enable SP mode access
3
Invalid for user codes and weekly timer codes
4 Reset all SP and UT (except SP#9) to default settings.
5 Not used
6 Connect to a Remote Diagnostic System
NOTE: #1 and #3 are effective while the main switch is ON.
#4 and #6 are only detected just after the main switch is turned on.
* See the troubleshooting section for the fuse table.
Function
Normal mode
RAM clear
SC detection disabled (except for fusing SCs)
Not used
Destination
RICOH
SAVIN
NRG
Others
Function
4-41
DIP SWITCH TABLE