Ricoh FT8680 Service Manual page 338

31 July 1995
[G]
[Q]
[O]
[P]
6. Remove the E-rings [G] on the pick-up roller shafts [H].
7. Slide the shafts [H] toward the rear of the machine. Remove the pins [I],
heart-shape cam [J], one-turn disk [K], and gears [L].
8. Remove the bushings [M] on the front and rear side of the 2nd pick-up
roller shaft and replace the 2nd pick-up rollers [N].
9. Remove the E-ring [O] and replace the 1st pick-up rollers [P].
NOTE: Reassemble the machine so that the 1st and 2nd pick-up rollers'
flat surfaces are parallel. Make sure that the one-turn disk [K] and
the pressure release cam [Q] installation directions are as shown
in the illustration.
[N]
[H]
5-109
[M]
[L]
[J]
A171R649.img
ARDF
[K]
[I]