Ricoh FT8680 Service Manual page 176

31 July 1995
A171I533.img
[J]
[E]
9. Reinstall all the covers.
10. Install the LCT grounding wire [A] together with the grounding wire [B]
from the power supply unit by removing and putting back the screw.
11. Pass 4 connectors of the interface harness [C] through the rear upper
hole [D] of the left lower cover, pass the grounding wire [A] under the left
lower cover, and install the left lower cover. (Do not fix the screw [E].)
12. (European version only) Install the by-pass feed lower cover [F]
(2 screws) and by-pass rear lower cover [G] (1 screw).
13. Loosen the nuts [H] of the feet [I].
14. Set 4 connectors to the connectors [J] of the LCT harness.
15. Mount the LCT unit on the copier (Insert the 2 mounting studs [K] into the
docking holes [L]).
16. Fix the LCT unit to the copier (1 screw [E]).
17. Screw down the feet [I] to level the LCT so that the LCT is parallel to the
copier.
18. Carry out the LCT Paper Feed Timing Adjustment by using SP mode
(9 SP Adjustment, 9-1 Paper Feed Timing Adjustment: LCT).
19. Check the LCT operation.
[G]
[C]
[K]
INSTALLATION PROCEDURE (LCT)
[D]
[F]
[L]
A171I532.img
3-17
A171I536.wmf
[A]
[I]
A171I534.img
[B]
[H]