Ricoh FT8680 Service Manual page 361

OTHERS
13.4 PAPER FEED ROLLER, SEPARATION ROLLER, AND
PICK-UP ROLLER REPLACEMENT OF THE BY-PASS
FEED TRAY
[C]
[B]
[D]
[A]
[F]
1. Close the by-pass feed table [A] and remove the LCT if it is installed.
2. Remove the table harness cover [B] and disconnect the connector [C].
3. Remove the 2 screws [D] for the by-pass feed bracket.
4. Unhook the by-pass feed bracket [E] while halfway opening the by-pass
feed table.
5. Remove the lower by-pass feed cover [F] (2 screws).
NOTE: This cover has been removed when the LCT is installed.
6. Remove the by-pass feed lower cover [G] and upper by-pass feed cover
[H] (2 screws each).
7. Slide off the pick-up, feed, and separation rollers [I, J, and K].
NOTE: Do not touch the surface of the rollers with oily hands. The paper
feed rollers used in the 1st ~ 3rd feed stations are different from
the feed rollers in the LCT and the by-pass feed table.
Distinguish them by the color of the side plate ("hub")of the
rollers.
[H]
[D]
[E]
A171R542.wmf
White one 1st ~ 3rd feed
Black one LCT and by-pass feed
5-132
[G]
[I]
31 July 1995
[J]
[K]
A171R543.wmf